Antique Tractors Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Ive got oil leaking between the axle splines and hub splines. the hub is also loose with the nut properly torqued. Replace worn hub right? Or, if they are tapered splines, why couldnt you put axle in lathe, and cut couple of thousandths off the end of the splines so the nut and washer will tighten hub to spline?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top