Antique Tractors Forum banner
1 - 3 of 3 Posts

· Registered
483 Posts
Discussion Starter · #1 ·
B/S 23D 9HP I had to replace the points and am not sure just how to gap them. There is a screw that goes in the block that has a nut on it. do I turn the screw to set the gap then run the nut againest the block to lock the adjustment?

:D Al
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.