Antique Tractors Forum banner

Cub crankshaft diameter??

2551 Views 4 Replies 3 Participants Last post by  John M
Would anyone happen to know what size the seal surface on the rear of the crankshaft be?? Need to get a speedy sleeve.
1 - 5 of 5 Posts
You might have seen the reply over on YT, but wanted to confirm that it is 3" even.
Thank you sir!! I always check in here first before going to YT.
The main journal is 1.623" my service manual does not list seal ID size, but I would expect it to be close to journal size
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top