Antique Tractors Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I have a 1963 Farmall 140 with a Woods Belly mower. I have a seal leaking on the pulley wheel.
How do I pull the wheel off?

There are 3 screws you can take off but the pulley does not slide off. May be caked on from paint. Should I just heat it up and tap it off?

Once you get that off, there are three more bolts thast need to come out. After you take them off will that piece just slide off so that I can replace the gasket?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top