Antique Tractors Forum banner

1 - 15 of 15 Posts

·
Registered
Joined
·
2,499 Posts
Discussion Starter · #1 ·
putting a clutch in a 2240.. single palte, ind pto.

what a pita.

cheapest i can find a kit is 900 smackaroos too :)


TO bearing seized.. ate fingers off.. etc..
 

·
Registered
Joined
·
168 Posts
wow that sounds like a lot of money .
2000 foot pound torque double plate for a hyway truck dont cost that much .
just a question you try napa or ai ?
 

·
Registered
Joined
·
2,499 Posts
Discussion Starter · #3 ·
napa couldn't get anything but the tob and PB... and yes.. I'm looking at an A&I dealer..

jd wanted about 1300$ :)
 

·
Registered
Joined
·
2,499 Posts
Discussion Starter · #5 ·
nothing left to weld on the fingers.. they wore clean thru like a saw cut them off. 2 of the 3 anyway.

media disc is too thin to put back in... gonna be forced to go with new parts.
 

·
Registered
Joined
·
2,499 Posts
Discussion Starter · #7 ·
i finally found a dealer with halfway decent parts and I should have my trans media disc, pressure plate, tob and pilot monday. by monday eve.. tractor should be back together..
 

·
Registered
Joined
·
2,499 Posts
Discussion Starter · #9 ·
disc, solid, no springs.. and well.. no media leaft. ti was thin enough to flafe off when i removed it. :)
 

·
Registered
Joined
·
2,499 Posts
Discussion Starter · #12 ·
throw out bearing came in wrong.. so I'm waiting on another one. suspect I'll have it monday sometime. once i get that. it will only be a few hours. I do need to weld up a new bottom for the bat box.. but will do that after I join her, as she's a lil easier to move floppy.. :)
 

·
Registered
Joined
·
2,108 Posts
Why does it feel like we are being hacked?
 

·
Registered
Joined
·
2,108 Posts
Thanks, guess that's what I meant.
Regards,
Chris
 
1 - 15 of 15 Posts
Top