Joined
·
102 Posts
This is my friends tractor, pulled it out of the bushes today after sleeping there for 10 years. Motor was stuck but we rocked it free and had it firing and wanting to start. I'm curious on what the heck it is
![]()
Need an ID
1 - 11 of 11 Posts
Joined
·
102 Posts
Also forgot to mention, has a 4 speed like the 8n and jubilee. But looks newer?
Joined
·
102 Posts
No tag on flat spot, takin starter off tomorrow to get fixed. Tried turning her over today but starter wouldn't engage. Hit it with a hammer but still a no go.
G
Guest
·Won't be a tag. Will be stamped into the casting on the flat right behind the starter. If not there then it will be stamped into a small flat ground spot on the left side of the motor below the head. If there it could be hard to read. Rub some chalk over it.
Joined
·
2,499 Posts
rear hubs and trans bellhousing says naa to me.
sn will be on an angled boss aft of the starter if a mid to late model, and onthe left front of the engine block under the head if an early model.
if an early model with a replacement engine from a later model and the mechanic did not xfer a sn.. it may have none and will need to be dated based on engine casting id.. and or other casting id's to get chassie year and engine year range. and size, as any of the 134/172 and 192 will bolt in there.. ( 144 as well.. but that's a diesel.. and this ain't )
sn will be on an angled boss aft of the starter if a mid to late model, and onthe left front of the engine block under the head if an early model.
if an early model with a replacement engine from a later model and the mechanic did not xfer a sn.. it may have none and will need to be dated based on engine casting id.. and or other casting id's to get chassie year and engine year range. and size, as any of the 134/172 and 192 will bolt in there.. ( 144 as well.. but that's a diesel.. and this ain't )
Joined
·
102 Posts
Update: found out that it is an NAA, with a 600 motor under the hood. Tried to get it running, has no spark. Cleaned the points and still nothin
Joined
·
2,499 Posts
both the naa and the 600 sers.. as well as 601 and 2000 4 cyl used a 134ci red tiger gasser ( or a 144ci diesel after 59' )
so essentially same engine.
check power to coil.. points opening .025 and not shorted out at feedthru insulator in side of dizzy.. check that points close. put a test lamp inlint to coil and spin starter over.. lamp should blink..
post back
so essentially same engine.
check power to coil.. points opening .025 and not shorted out at feedthru insulator in side of dizzy.. check that points close. put a test lamp inlint to coil and spin starter over.. lamp should blink..
post back
Joined
·
102 Posts
It is not blinking. Tried tonight.
Joined
·
102 Posts
Not making contact at all. She's on the backburner while we get this 75 acres of hay in
1 - 11 of 11 Posts
